Jinan aluminum embossing machine was switched on three-phase power switch, and then turn on the power switch on the machine side of the control box, if there is high-cycle switch, temporarily not open, then open the electric power switch, this time, the vacuum tube and heat mold began to warm up.
Jinan aluminum die embossing machine before putting down insulation, installed on the extreme upper die, open tryout switch down to start debugging mode engaged position, if the next engagement is not good, move the lower die, if the level of irregularities, the adjustments four pillars of the child on the mold.
Jinan embossing machine aluminum die after a good tune, adjust time controller, fall time that is running on the die to the die clamping time, welding time that the output time, cooling time, that the curing time, the three time to be flexible application There is no fixed number of values.
The above operation as more than 10-15 minutes, and when you reach the desired temperature, the high-cycle switch marked to begin operational testing. Jinan finished aluminum embossing machine effect, the temperature, the power output of the same tune, pressure, high-output four weeks aspects decision.